I have several 10 round magazines for the Beretta 84 BB. The magazine body is the same as the 13 round mags as is the spring and the follower. (identical) The magazine is limited by dimples pressed in from both sides that stop the follower. Is there any drawback to me getting in there with a file and filing off the dimples? It would leave to 1/8" square holes in the mag, but I don't think, that if I get it good and clean, on the inside, it will be a problem. The process would remove the bluing and invite rust, but I am rust's worst enemy. Any thoughts? anyone else done it?
Doggoneit
Joined
·
448 Posts
Richard's point is well-taken but I note that Mec-Gar Beretta 84 10-rd mags and 13-rd mags are the same affordable $21 price each (before tax & shipping), as well as readily available, from places like GunMagWarehouse.
I guess if you offer up the used 10-rd mags cheaply enough then there would probably be a market for them, but many people would likely just buy a new 10-rd mag, considering how reasonably priced they are.
If you do decide to remove the dimples I think a small drill bit will be quicker and cleaner than a file. Just a a quick de-burring and you're done.
-Bob
I guess if you offer up the used 10-rd mags cheaply enough then there would probably be a market for them, but many people would likely just buy a new 10-rd mag, considering how reasonably priced they are.
If you do decide to remove the dimples I think a small drill bit will be quicker and cleaner than a file. Just a a quick de-burring and you're done.
-Bob
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
