Gunboards Forums banner
1 - 1 of 1 Posts

·
Silver Bullet member
Joined
·
39,653 Posts
Discussion Starter · #1 ·
I saw a segment on How It's Made this weekend that featured some of these blades. Here's a video of a guy making a horizontal slash and cutting through 24 full beer cans. Now wait, before you freak out, like I almost did, I understand that they drank the beer and then filled the cans with water. That was a relief! (Well, the Olympia can he practiced on coulda been full without hurting my feelings, but that's just me...)


Anyway, I am hot for some of these blades. Only thing is, they run anywhere from $350 or so up to almost $500. But the flip side of that coin is that you aren't buying some cheap mild steel machete for $7.95 from your local hardware store. They're made from .25" steel hardened to Rockwell 54. That makes for a serious pig sticker.

http://www.zombietools.net/products/blades/
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top