Gunboards Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
704 Posts
Good luck.
If you look around hard enough on the internet you will find pictures of bits and pieces. Since the breech area looks similar to an MP40/1, I would start with an MP40 bolt.
For the past 4 years I've been going through the same spiel with a Gerät 06H. I'm close now.
 

·
Registered
Joined
·
4,691 Posts
I sold my spare Erma EMP bolt about 2 months ago but I have a registered Erma EMP gun. What bolt dimensions do you need?
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
I sold my spare Erma EMP bolt about 2 months ago but I have a registered Erma EMP gun. What bolt dimensions do you need?
Bill,

Thanks for response. I need all dimensions. If i could rent it for a week we could reverse engineer it and we would make one. We are a complete machine shop. I will pay you and make you a spare bolt. email me at [email protected]

jerry
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top