Gunboards Forums banner
1 - 15 of 15 Posts

·
Registered
Joined
·
664 Posts
Discussion Starter · #1 ·
I've been looking for a set of wood grips for my IZH-70, so I would like some recommendations. I'm mainly after a grp set that is laminated like the russian AK handguards. I guess I should add that my IZH is a single stack .380 one. Any ideas?
 

·
Registered
Joined
·
2,303 Posts
Not a whole lot of choices, Marshall grips is about the only place I know of to get them these days. There used to be a guy on Ebay but I have not seen his for a while.

http://www.marschalgrips.com/
 

·
Registered
Joined
·
664 Posts
Discussion Starter · #5 ·
I have a set of Marschal grips on my TTC, Very nice grips!
 

·
Registered
Joined
·
664 Posts
Discussion Starter · #7 ·
So, I am thinking about ordering a smooth barewood grip from Marschals so I can finish it myself with Tru-Oil. What wood would look best with Tru-Oil on it? I'd like all of your opinions on this.
 

·
Registered
Joined
·
785 Posts
So, I am thinking about ordering a smooth barewood grip from Marschals so I can finish it myself with Tru-Oil. What wood would look best with Tru-Oil on it? I'd like all of your opinions on this.
Guess I'm old fashioned, walnut is my wood of choice. Have not had time to post the pictures but just received two sets of grips from Marschal for my FEG SMC 918 and FEG R61.
 

·
Registered
Joined
·
664 Posts
Discussion Starter · #9 · (Edited)
Guess I'm old fashioned, walnut is my wood of choice. Have not had time to post the pictures but just received two sets of grips from Marschal for my FEG SMC 918 and FEG R61.
I have walnut grips on my TTC. I'll slap up a picture of them when I get home.

Here is the grip I was originally interested in, but I found out it is for an MP-654K, which is based on the PMM, not the PM.
 

·
Registered
Joined
·
153 Posts
So, I am thinking about ordering a smooth barewood grip from Marschals so I can finish it myself with Tru-Oil. What wood would look best with Tru-Oil on it? I'd like all of your opinions on this.
I put tung oil on my Maple grips. Love them. Did this first for a FEG PA63. Then my Mak. I will try to get pictures of the Mak up later
I did just refinish it. After 4 years of carry, the oil needed reapplying.
 

·
Registered
Joined
·
11,224 Posts
Does anyone remember a poster named scootermak and the wood grips he made grinding the aftermarket plastic grips and gluing on scales of wood? They looked pretty neat, but I cant find any history of the posts...
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top