Gunboards Forums banner

What size clips for retaining FCG pins?

705 Views 5 Replies 6 Participants Last post by  AbueloMark
Put a tapco G2 in my SAR. Figured i would replace with retainer plate but of course the holes dont seem to be in the right spot exactly and the plat will not hold the trigger pin in tight. It's not the plate i tried it on another ak. And because the shepards crook is the most aweful thing ever made i buggered it up real bad taking it out. I did get it back in but it is popping out of the little slot after few shots.

My question is what size are the little banna clips that you can use as that seems to be my only option at this point. Can they be found at hardware store?
1 - 1 of 6 Posts
+1 for shephereds hook vs plates or clips.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.