Gunboards Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
4,381 Posts
Discussion Starter · #1 ·
If a carcano is marked Tubata on top of barrel knocks form doesn't this mean barrel was
lined using the tubata process? If so does this hold up under normal use?
 

· Administrator
Joined
·
10,485 Posts
"Tubata" ( Italian "Tubed"): A repair process for worn-out barrels in the 1893-c1910 period, for M91 Barrels which had "Burnt out" by the use of hot and erosive Ballistite Loaded M91/95 6,5 cartridges (before the introduction of "Solenite", a much "cooler" propellant.)

The System obviously held up well, since there seems to be no differance in the Issue and Use of "Tubata" Rifles during WW I, nor any particular notations regarding Problems in service.

For Nowadays Use of a "Tubata" M91, care should be taken, as with any 100-year-Plus Rifle, as to what Loads one uses, especially when handloading.

Regards,
Doc AV
 

· Registered
Joined
·
2,729 Posts
It may be of interest to note that the Finns copied the barrel re-lining method from Italy and called it "Salerno method". I am not aware (or just ignorant ;-) ) of any major repair facility (i.e. direzione d'artiglieria) having been in Salerno, so the name might be a proper name rather then a geographic indication.

Carcano
 

· Registered
Joined
·
1,610 Posts
It may be of interest to note that the Finns copied the barrel re-lining method from Italy and called it "Salerno method"...... so the name might be a proper name rather then a geographic indication.
"Salerno" was the family name of the person that invented the method that was applied by the Terni arsenal, first to Vetterli Vitali and then to '91.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top