Gunboards Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
38 Posts
Retap the threads and clean them up, below is where to get the British type taps and dies.

Screw, ejector = 3BA (Number three BA (British Association) Thread type)
http://www.britishfasteners.com/threads/index.html

http://www.britishfasteners.com/mm5/merchant.mvc?Screen=PROD&Store_Code=BTF&Product_Code=4395&Category_Code=250
Thanks for your help in a few of my post Edward. I ordered the 3BA Tap and two of the British Fasteners 3BA Cheesehead screws in 1/2 inch to cut down to size. I already eBayed an original ejector screw to use but got spares in case I have problems. I also ordered new Extractor and Firing Pin springs from Midway and a bolt tool (from gunbroker) to make this a completely refurbished gun. Thanks Again
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top