Gunboards Forums banner
1 - 1 of 1 Posts

· Platinum Bullet member
1,610 Posts

You did the right thing by spraying oil under it. I use WD 40. The handguard is most likely stuck due to dried grease between the barrel and the wood. It does fit under the rear sight via a small metal piece attached to the wood, and this may be rusted onto the rear sight. Put some oil on that, too. Then perhaps wiggle it a bit to loosen the wood, Be really careful as the wood is thin and fragile.

John in Charlotte, NC
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.