Gunboards Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
364 Posts
Discussion Starter #1
I know this question sounds dumb, but is there a bushing that goes between the trigger housing and receiver at the rear trigger screw on the K98.

Doug
 

·
Registered
Joined
·
5,090 Posts
does any one know the measurement of the bushing?
ive delt with em. some stocks dont fit well if the rear tang and busihing dont match up on
rc or mixmasters. these are known as 'pillar bedded' or some such. ive found for targeting
the match or 'fit' is important. ive done some serious 'karate chop. groups when the rc stock didnt fit well with the metal. if its to loose in back it will teeter totter when warm. also it will ride hard on the bands if you try to tighen to hard. if to high it rides the stock/ loose bands.
hope this helps
 

·
Gold Bullet member
Joined
·
995 Posts
Any one have a spare one laying around.
Doug
doug,

drop me a pm or email... I have one that I pulled out of a badly spoterized cupped butt plate k98 stock. It does have some surface rust. However, it is fully functional and original...
 
1 - 6 of 6 Posts
Top