Gunboards Forums banner
1 - 2 of 2 Posts

·
Gold Bullet member
Joined
·
801 Posts
Discussion Starter · #1 ·
I am building a long lee (1896 LE1) from pieces and I finally got a butt stock. its NZ marked on the plate in the usual place. when I went to fit it the bolt that I have wont go through far enough. its about 2" too short . the bolt I am using came from a SMLE. I have a martini bolt but its shorter again
I have looked online but can not find any info on bolt lengths.
help I need a bolt
 

·
Registered
Joined
·
646 Posts
6 Inches from under the collar to tip, collar 3/16 " usually. Total OL 6 & 3/16" later stock bolts converted/made like the sMLE with squared ends to lock into plate on the rear of the stock, care need in removing wood as the warning stamp is usually worn away.
 
1 - 2 of 2 Posts
Top