Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
232 Posts
Use the edge of a hard surface table to apply pressure on the cocking piece notch on the bottom. Push downward with the entire bolt and at the same time attempt to move the safety to safe. More than likely it's the cocking piece that needs changed, may be nothing wrong with it, just doesn't jive tolorance wise with the other parts.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top