Gunboards Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
3,326 Posts
Discussion Starter · #1 ·
I'm trying to switch out the FCG on an AMD-65 but, the builder used the "C" type clips to secure the hammer and trigger axis pins instead of the shepherd's hook. Is there a trick to getting these things out? I've tried grabbing them with needle nose pliers but I can't get a good enough hold on the little things.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top