Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,034 Posts
Can't say for sure. The failures seen in your photos is typical of worn out over worked brass. However, if only reloaded 4 times produced these failures normally I would say you have excessive head space. And you may. The PPU may just be a little thicker and have not reached failure point yet.

How often do you need to trim the OAL after full length resizing?

Motor
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top