Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,174 Posts
The industrial manufacturing process for the D bullet was by swagging and not by turning.

The early production for the developpment of the best bullet profile was done by turning, but once the design was approved, the bullets were swagged, and the location of the maximum diameter did not matter at all.

The material, Brass 90/10 would have been a poor choice for an industrial fabrication by turning, but was a good choice for swagging.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top