Gunboards Forums banner
1 - 8 of 8 Posts

·
Admin Emeritus
Joined
·
19,073 Posts
I was going to say that it was one hell of a find as most don't fit the base or vice versa. They were hand fit on a one to one basis .
 

·
Gold Bullet member
Joined
·
1,192 Posts
Discussion Starter · #7 ·
Turfmn, did Igor ship the screws and pins for your PEM mount when you received it? I have one I got from him on Ebay but am still awaiting the screws and pins.

No, I didn't get pins and screws. I used a set of pins and screws that I had from a PU setup. I had to drill the pin holes in the base a little larger to fit the pins I had. The PU mounting screws fit, but the PU locking screws were too big for the base.

Now I just need a PEM scope :)
 

·
Copper Bullet member
Joined
·
75 Posts
Mount screws

Thanks for the reply Turfmn. When I last heard from Igor a few weeks ago he said that he was waiting to get them from overseas and should have arrived in about three weeks. I will just wait a little longer....sigh !!!!
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top