Gunboards Forums banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
957 Posts
Discussion Starter · #1 ·
I lubed the bot assembly and when shooting I get a little oil flinging on my glasses. I assume it from over lubing the bolt assembly.
Can I use some sort of dry lube on the bolt assembly?

Could there be another reason for the oil on glasses like chamber gasses blowing back?
 

·
Platinum Bullet member
Joined
·
2,099 Posts
It does sound like you're overdoing the oil a bit. there's no need to slather on the oil a light cost of either a good quality gun oil or gun grease should solve the problem. I use the same white lithium grease that I use on my M1 Garand which is available a any well stocked hardware store.
 

·
Administrator
Joined
·
19,287 Posts
Try no oil. It Dorset need it. If you must use a small brush and wipe rig on the cocking piece mating surfaces. The MN bolt needs no oil.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top