Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,080 Posts
Liquid Wrench and Kroil work better than PB. Let it soad a couple of days. But if the retaining pin is rusted into the pivot pin that badly you'll probably have to carefully break off the ends of the retaining pin with a small punch and or chisel. If you can get it to bend out from the reciever you can grasp it with tiny needle nose pliers and try to work it back and forth - it'll probably break off. Then drive the site pivot pin out. Once the pivot pin is out you can drill the hole out and use a new roll pin. Use a vice and be careful not to gouge the reciever.
Why does the site need to come off? I'd just leave it be and clean the rifle up around it with qtips and solvent.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top