Gunboards Forums banner
1 - 2 of 2 Posts

·
Gold Bullet member
Joined
·
785 Posts
Discussion Starter · #1 ·
I see axis pin is retained by the retaining pin. I've soaked it with P Blaster solvent and tried driving the pin out from each end but the pin doesn't seem to be moving. I even bent my nice punch from Brownells. :-( Any suggestions on how to remove this pin would be welcome. TIA
 

·
Gold Bullet member
Joined
·
785 Posts
Discussion Starter · #3 ·
Thanks for the info. I got the pin out at the shop today. Combination of more P Blaster, a little heat and a stronger punch. The sight was removed for installation of Accumounts scope mount.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top