Gunboards Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
410 Posts
Discussion Starter · #4 ·
I really like the look and feel of it and Kens rivet work looks fantastic. Only issue is when I first pulled the bolt back it locked in the rear most position and I had to take the top cover off to get the bolt carrier not to hang up on the rails. I contacted Ken about this and he said the American made receivers are often slightly off in the hole placement for the rivets and the way the rails are cut. He said to run the bolt a bit and 9 times out of 10 it should wear in in a mag or two. I haven't shot it yet but have worked the bolt and it seems to indeed be wearing in. It has a Childers receiver and an ALG trigger so I hope it will hold up and be fun to shoot, but I think I know it will be. I may have to change the lower handguard though, as much as I like the look and feel of it, that dong sure does make mag changes slow and awkward.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top