Gunboards Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
Have a beautiful set of Marshal grips that did not fit my gun. I have tried to work on them a little bit, but my skills at fixing things are a 1 on a 1-10 scale. One grip is in perfect condition, the other one (on the left in picture below) is nicked up ever so slightly in the upper right hand corner. It will never show because it goes under the safety. On the unfinished side, there are some marks where I tried to thin it up some.

If you want to take a chance on getting them to fit, I will send them to you for approval. If you get them to work, send me $25 plus postage. If you don't, throw them away. I will trust you on this. These are so pretty, I would like for someone to get some use from them.

Let me know.

 

·
Registered
Joined
·
74 Posts
Discussion Starter · #4 ·
mpi, you got em. Send me your address in a PM and I will get them to you. Hope they work out, they are beautiful.
 

·
Registered
Joined
·
355 Posts
Just for my info, Dennis has a good reputation here - did you approach him about making it right?
 

·
Registered
Joined
·
9 Posts
Was it only one grip that didn't fit? I had to drill a tiny hole in the bottom of my left grip (I think it was the left) because there was a tiny pin sticking out about 1/16" of an inch or so that was hitting the flat side of the wood.
 
1 - 7 of 7 Posts
Top