Gunboards Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
918 Posts
Mark the outside face of the extractor with good permanent marker or Dykem if you have it. Try to chamber the dummy round, then remove the bolt. If the extractor is hitting the receiver or extractor cutout, the marking should be scraped off. After that, a dab of white-out on the extractor should show where it is hitting inside there (close, at least).
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top