Gunboards Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
127 Posts
Discussion Starter · #1 ·
I could be wrong, but this looks like a dead ringer for a Swede trigger guard assembly, and I can’t place the markings on it. Research has done me no good, so here we are! What do you gents make of this?
3817984
3817985
 

· Moderator/Diamond with Oak Clusters Bullet member
Joined
·
9,924 Posts
That is NOT a Swedish trigger guard anyway . The Swedes never numbered the trigger guard on the outside forward tang & did not use letters in the serial number .. They were numbered on the back rear of the mag well with the last 3 digits of a serial number . The Swedish floor plates were numbered in the center along with a Crown . Probably German contract Mauser of some kind . Try asking on the Mauser Forum . They have a broad view on the subject .
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top