Gunboards Forums banner

1 - 3 of 3 Posts

·
Gold Bullet Member
Joined
·
134 Posts
Discussion Starter #1
I was contacted recently by one of the big U.S. reloading components houses. They're apparently considering a run of 8x58R Danish Krag brass, and are looking for some reliable dimensional drawings along with a few original loaded rounds from two or more sources.

I have some brass made up by Buffalo Arms which I have fired in my m/89 Danish Krag, and I can direct them to some of the standard references out there, but I don't have copies of original dimensional drawings or any original loaded rounds -- how about any of you out there in cyberspace?

Please e-mail me off-line if you can help.

TIA,

Tom

www.vintage-gunlore.com

[email protected]
 

·
Moderator / Gold Bullet member
Joined
·
2,661 Posts
Hi Tom

Nice to see you back. If you go over to the Swedish civilian firearms forum and look through the topics you'll see several on this subject that have been heavily discussed in the last couple weeks. There's also a link to a cartridge drawing that was sent to me by the tech dept at Norma Precision in Sweden.

Dutchman
 
1 - 3 of 3 Posts
Top