Gunboards Forums banner
1 - 1 of 1 Posts

Platinum Bullet Member/Moderator
2,990 Posts
Discussion Starter · #1 · (Edited)
This is a shorter length version of the 2 inch illumination/flare launcher cup.


It may be British as the mount has a partial ring to locate on the No. 1 rifle nose cap bayonet boss. The body has the following markings, "R & S Co. / 405

Auto part

The cup is shown next to a standard 2.5 inch grenade cup. The 2 inch bore cup has and over all body length of 7 3/16 inches.

There has not been much written about all the different British Commonwealth cups and spigot launchers used in the various wars.

Comments please.


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.