Gunboards Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4,356 Posts
Typically, you'll have to lightly grind away the welds on the outside, then use an "easy-out" to remove the screws. However, I've heard some guys state that they put a screw in from the inside and turned it through, which got the welds to break free, if they were thin enough. Never tried that one, myself, however.

John
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top