Gunboards Forums banner
1 - 1 of 1 Posts

· Gold Bullet Member and Noted Curmudgeon
Joined
·
101,781 Posts
I'd either fit it at the front and then drill out (or ream) the rear hole oversize, fill it with a piece of steel (or for that matter - brass) stock and then drill for the rear pin. Or fit it at the back, built up the front with weldment and file or mill to fit.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top