Gunboards Forums banner
1 - 1 of 1 Posts

· Registered
2,536 Posts
Discussion Starter · #1 ·
Hope this hasn't been posted before. I was considering going this route with a kit and receiver, but after seeing all of this, I shall pass...

Guy tried bending his own flat.

When the bolt and carrier and so on didn't fit right, he naturally ground off the offending areas...

Yes, that's the crucial area of the trunnion that takes all of the firing pressure, ground away so that everything would fit...

And when he finally gave it all up, he demilled the gun in a way so that he could keep the that he could try refitting the more parts to it later...
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.