Gunboards Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter · #1 ·
I do a lot of dry-fire trigger practice with all my guns except my CZ-52. This morning I tried to make a snap-cap from an empty case with a piece of pencil erasor stuck in the hole where the primer used to be.
To my disappointment, I found that the firing pin quickly punched a rather deep hole in the rubber, and I didn't trust this setup to protect the firing pin anymore.
Anyone have any ideas? Are there commercial 7.62x25 snap-caps available anywhere?
 

·
Diamnd Bullet member
Joined
·
410 Posts
I do a lot of dry-fire trigger practice with all my guns except my CZ-52. This morning I tried to make a snap-cap from an empty case with a piece of pencil erasor stuck in the hole where the primer used to be.
To my disappointment, I found that the firing pin quickly punched a rather deep hole in the rubber, and I didn't trust this setup to protect the firing pin anymore.
Anyone have any ideas? Are there commercial 7.62x25 snap-caps available anywhere?

Fill the primer pocket with silicone caulk and let dry 24 Hrs. This makes an excellent low cost snap cap.
 
1 - 4 of 4 Posts
Top