Gunboards Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
2,087 Posts
Discussion Starter · #1 ·
Did the Fins ever modify the cocking knob on m27 bolts? I'm asking this because the connecting bar w/wings will not fit correctly under the cocking knob on my m27. The cocking knob is the early type with relief cut.
 

·
Administrator
Joined
·
3,487 Posts
If the winged connector bar is a NOS piece and has never been on a rifle before, it will most likely need to be fitted with some careful file work. I got a couple of these from Vic a few years ago and both had to be fitted before they would slip onto the cocking piece.
 

·
Registered
Joined
·
2,087 Posts
Discussion Starter · #6 ·
If the winged connector bar is a NOS piece and has never been on a rifle before, it will most likely need to be fitted with some careful file work. I got a couple of these from Vic a few years ago and both had to be fitted before they would slip onto the cocking piece.
Just like you said, it needed to be fitted. Works fine now, thanks.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top