Gunboards Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
162 Posts
Discussion Starter · #1 ·
and cleaned it but, I ended up with a part I don't know what to due with. Its a post 64 and the bit is a small rectangle shaped bit with a hole in the center. The thing is about 4 by 6 MM and thin sheet steel. Help me with my new Winnie I am most grateful.
 

·
Registered
Joined
·
3 Posts
and cleaned it but, I ended up with a part I don't know what to due with. Its a post 64 and the bit is a small rectangle shaped bit with a hole in the center. The thing is about 4 by 6 MM and thin sheet steel. Help me with my new Winnie I am most grateful.
I don't know which part that is but this may help.

http://www.castbullet.com/misc/tdown.htm
 

·
Registered
Joined
·
162 Posts
Discussion Starter · #4 ·
Well I thoght it pretty the same as my pre 64

And I got my self into this lol. Guess I will be a Brownell's customer for a manual and btw are all used M94's garenteed to have a buggered band screw? Thinking this is a rebounding hammer set up and I haven't a chance in hell to get it set up right w/o the manual.
Glad my older M94 dosen't have these "improvements".

Thanks Guys Y'll my best.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top