Gunboards Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hey guys today I went about dissembling my Ljungman, I commpressed my barrel bands and they have not came back up, I don't really know how to put them back on now. Now sure if I am exaggerating but I definitely have no clue what to do. Any expert advice?
 

·
Moderator/Diamond with Oak Clusters Bullet member
Joined
·
9,683 Posts
If the bands are tight on the sides of the slot , take an Exacto knife & scrape the sides a little until the bands move freely . They can be knocked out with a small punch . Easy to put back in place .
 

·
Registered
Joined
·
1,990 Posts
If the bands are tight on the sides of the slot , take an Exacto knife & scrape the sides a little until the bands move freely . They can be knocked out with a small punch . Easy to put back in place .
Go slowly knocking them out. If they are really tight, the stock could chip.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top