Gunboards Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
Ran across a G3 furniture set that was tan/honey brown colored. Does anyone know who used these stocks?

sbl
 

·
Diamond Bullet Member/Moderator
Joined
·
54,476 Posts
If only they weren't such a pain to have built! That's the biggest draw back!
I built a couple and really found them no tougher to build than the AKs I built (probably easier in some respects), they are just different and I think that throws most off.
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #9 ·
When I find a rhodesian service FMP G3, then I guess I will try my hand at a build. But I have zero experience or tooking to do it myself and would need a builder.
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #10 ·
Guys,

i am am a noon to the G3, and was wondering if all g3's have the etched 3 digit serialization on the bolt/bolt carrier. And, if not, hen who etched them. I know I have seen the RA serial numbers on the rhody kit parts, but it seems as the 3 digits numbering differs in the manner of etching(less like an electro-pencil) then those rhody RA numbered guns.
 
1 - 10 of 10 Posts
Top