Gunboards Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
4,717 Posts
Discussion Starter · #1 · (Edited)
So, I'll be using it for the maus if I can ever find any .323 bullets and I plan on using it for the .280 and maybe the 7mm-08 too. I'll try the imr 4350 on the latter two also.

Sol, will the 150 have enough shoulder to spin accurate in a postwar Czech mint barrel? or should I look for the 170 by speer? Hornady?
 

·
Platinum Bullet Member
Joined
·
59,080 Posts
Don't know about the bullets you mentioned... However 4064 dies very well in the 2 calibers I've used it for..5.56 and 30.06

Sent from my XT1080 using Tapatalk
 

·
Moderator/Gold Bullet member
Joined
·
9,167 Posts
4064 has been great in every milsurp rifle I've reloaded for, even 6.5x55 Swede.

Lyman- You've used it for 5.56??? I never thought it would have done well for that.
Pat
 

·
Registered
Joined
·
5,106 Posts
yea thats good to go on 4064. great powder
the three i will try to use are
aa2520
4064
Varget.
of course a 150 will work. czech are some of the best barrels.
you can get a 150 moving out velocity wise. 2900 fps...
dont seat a 150 to deep now.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top