Gunboards Forums banner
1 - 9 of 9 Posts

·
Diamond Bullet Member
Joined
·
2,400 Posts
Discussion Starter · #1 ·
Am wondering what those of you who shoot real and resnipered mil surps; how do you make sure scope
screws and such don't fall out? nail polish, Loctite, etc. or do you just check and re-tighten each time?..:)
 

·
Silver Bullet member
Joined
·
187 Posts
DaWoof
I use the removable Loctite, just incase I need to remove them. Also I put a reference mark on the screw. That will tell you if has backed out.
Bob
 

·
Registered
Joined
·
1,246 Posts
just make sure the screws are tight before each range trip
 

·
Diamond Member with Oak leaves and Swords
Joined
·
2,934 Posts
You are only supposed to use "a drop". I've seen and had to remove fasteners that are slathered in the stuff and it is a pain.
I just insure the are snug and check occasionally.
 

·
Diamond Bullet Member
Joined
·
2,400 Posts
Discussion Starter · #9 · (Edited)
Thanks everyone; when you have a lot of money and unreplacable parts tied up in
these rifles you hate to mess them up...
 
1 - 9 of 9 Posts
Top