Gunboards Forums banner

Flying brass

1748 Views 11 Replies 10 Participants Last post by  PM66
My Bulgarian Makarovs send the brass flying over a large area, while my 1911 .45cal pistols send their brass in tight groups on the pavement.

Is there a way to tighten the Makarov brass groupings on the ground? I usually loose one casing out of each magazine. I don't mind "far", but I'd like to reduce the "wide".

Accuracy is just fine with both the Mak and 1911 pistols.
1 - 1 of 12 Posts
Three words:
"low earth orbit"
That's where all my unfound brass goes (I think).
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.