Gunboards Forums banner
1 - 12 of 12 Posts

· Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
My Bulgarian Makarovs send the brass flying over a large area, while my 1911 .45cal pistols send their brass in tight groups on the pavement.

Is there a way to tighten the Makarov brass groupings on the ground? I usually loose one casing out of each magazine. I don't mind "far", but I'd like to reduce the "wide".

Accuracy is just fine with both the Mak and 1911 pistols.
 

· Administrator
Joined
·
8,454 Posts
Attach a net to the pistol?

Reloading 9x18 is made difficult by the difficulty of finding your brass. I shot some 36 rounds yesterday of Ammonet ammo with Starline casings and found about 2/3rds of the cases. And that's in a fairly controlled area for them to land in. These things really make brass vanish.

Putting on heavier springs doesn't do much if anything. I once ran a test using a Makarov with 17#, 19# and 21# springs. The difference in the distance that casings were thrown was just about zip.

I think you have to control the environment, not the pistol.
 

· Administrator
Joined
·
4,934 Posts
Like NB said it's a problem if you want to save the brass, shooting at indoor range no problem, out doors good luck. If you think maks launch the brass into LEO then try to find some from a CZ-52, I think some of it goes into HEO and never returns.
 

· Registered
Joined
·
158 Posts
I was shooting some brass though the Ruger the other day and wanted to save the brass so I laid out a 8'x10' tarp and positioned myself so I caught most all of the brass. Then I tried out a Makarov I just purchased and the cases didn't even land close. lol
 

· Registered
Joined
·
11 Posts
Discussion Starter · #9 ·
DWD, yes, that's what I did . . . I need a larger tarp for gosh sake! The Mak shells spread out in a very large area. And, as I said, I lose about one every eight when I round up the empties.
 

· Registered
Joined
·
2,315 Posts
I noticed this with my wifes Bersa also, the scattering of empties in a large area. I started thinking that perhaps it is something created by the nature of the blowback pistol. Each cartridge will have a very slight variation in power and this difference may create different pressures on the spring which slows the slide thus throwing the cartridge differently each shot. This differs from gas operated pistols.

Might be completely wrong, but that is what I thought might be a cause of it.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top