Gunboards Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,012 Posts
I found most of the hand fit triggers have a thickness of between 0.040" and 0.050" w/some as low as 0.035". These spring/sears are also hand lapped and fitted, the original angles are maintained but polished true. I believe the work was done in fixtures because of the consistencies achieved.-SDH
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top