Gunboards Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
655 Posts
Discussion Starter · #1 · (Edited)
I had mine broken two years ago on my Sako m 39. I removed the one from my Russian M 91.30 and installed it . It worked okey but its not as crisp and light as the Finn M 39 trigger spring.
Now where can i find original Finn made trigger springs for M 39 ? Or are all M 39s customized by the Finn armorers to have that light trigger pull before leaving the factory ?

Can someone show a pic of the difference of the two?

Thanks
 

·
Registered
Joined
·
1,011 Posts
I found most of the hand fit triggers have a thickness of between 0.040" and 0.050" w/some as low as 0.035". These spring/sears are also hand lapped and fitted, the original angles are maintained but polished true. I believe the work was done in fixtures because of the consistencies achieved.-SDH
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top