Gunboards Forums banner
1 - 1 of 1 Posts

· Registered
46 Posts
Discussion Starter · #1 ·
Hi -
I was looking at my old Model BM today, the one with the extraction problem. Comparing it to my other one, I noticed that the ejector is is bent up away from the slide rail in the back. There is a noticeable gap between the ejector and the frame rail, and a straightedge laid along the top of the ejector shows that it is not flat. Has anyone replaced the ejector on one of these, and if so, do you have any tips or tricks for doing it? It seems fairly straightforward, but I thought I would try to benefit from the experience of the group.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.