Gunboards Forums banner
1 - 1 of 1 Posts

· Registered
247 Posts
Discussion Starter · #1 ·
Purchased a DSM 34 (Mauser) last week that was missing the half ring between rear sight and the handguard as quite a few others I've seen....I used a full ring from 1917 enfield rifle, cut it and bent it to fit around the handguard then just ground and shaped it...polished and blued. Hard to tell from original......
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.