Gunboards Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
232 Posts
Discussion Starter · #1 ·
I have this pair of grips which look exactly like those on my Huntsman and post 47 Woodsman. The width of those on the pistols measure around 1-1/4" wide. These grips I have measure around 1-1/8" wide. When you fit these to the Pistols you see a little daylight on front side where the panel does not lay on the front side part of the frame. Other than that they are same in screw hole pattern, design(checkering), Rampant Colt and OAL. Any Help to claify/identify is appreciated. Thank You.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top