Gunboards Forums banner
1 - 2 of 2 Posts

· Read Only
Joined
·
4,633 Posts
Depends on how smooth your weld surface is when you get done. Inside surface, not outside. You could have some odd effects on your accuracy if the surface isn't smooth. For my money, you'd be ahead to just shorten the barrel behind the ports and remount the front sight.

Was digging through my old gun mags last night, and found reference to a set of ports that could be turned on and off in a compensated gun. It's been a while since I paid attention to the Taurus porting system. Is there a separate gas ring cut for each port? If there is, I may have a fix for you that won't involve welding.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top