Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,114 Posts
Hi l3enilli,

If the ports are round, I would just tap the holes & install set screws. You WILL ruin the barrel with any welding.

Other thoughts-
Sell the revolver off or trade it. Taurus might change out your barrel at a low cost, just ask!

Best to you,
point6
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top