Gunboards Forums banner

Cleaning the SVT with Scope and Mount

790 Views 6 Replies 4 Participants Last post by  turbodan
Hi all.

Since SVTs were a hot topic today, wanted to throw something out there that I recently had to deal with.
I just added a Numrich repro mount and PU scope to my SVT40. After a range session I prefer not to take down the mount setup after spending the day fine tuning. I was able to do my typical field strip for cleaning, but it was VERY difficult getting the bolt assembly back in place. The mount base really gets in the way, trying to work around the scope doesn't make life much easier. Should I just suck it up and take the mount down? Not worry about disassembling the bolt for cleaning? Hit the gym so I can put more elbow grease into reassembly? For those of you that shoot with a scoped SVT, how do you clean yours?

Regards,
JB
1 - 2 of 7 Posts
You can get it apart with the mount and scope on. Maybe I'll put up a video because I don't know how to explain it. Its definitely possible. The trick is getting the recoil spring guide rod out. Once you get that done you're there.

I'd certainly be interested in a vid. Getting rod out wasn't an issue for
me. Getting the bolt cover back with the rod seated properly was the tricky part.
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top