Gunboards Forums banner

bolt safety ?

1024 Views 4 Replies 3 Participants Last post by  Mike442
Is there anything in the Swede bolt that holds the safety in the off position.?My safety seems to move around too much and sometimes after i fire a round i think the bolt is locked up but its the safety flopping up just enough to catch the bolt .If i hold the safety down then the bolt opens ok . Arnie
1 - 2 of 5 Posts
I think i will rub some silicone rubber on the shaft and then let it set up after sliding it back in . I wonder how hard that shaft is? I coud cut a groove in it to take a small rubber O ring .Arnie
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.