Gunboards Forums banner
1 - 2 of 2 Posts

·
Senior Member
Joined
·
1,693 Posts
Discussion Starter · #1 ·
Hello. I was attempting to disassemble the bolt in my M98/48 Yugo and I can't seem get it. I pressed the plunger and began to rotate the bolt and now it is stuck I believe because I didn't put the safe in the middle position, it's in "fire". What do I need to do to get it back so I can disassemble it? Thanks.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top