Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
In reassembling my Beretta Tomcat (Inox), I may
need some help in techniques for getting the
hammer-spring resinstalled. In the attached
picture, you can see that the spring has separated
from its two parts.
Any suggestions?
Also, is there a complete set of reassembly instructions
somewhere on the internet?
(I think the hammer-spring part is the only part I will
need help on. It is incredibly stiff -- it is hard to see
how to get it reconnected to the attached shown pieces with
your fingers alone...)
(I have another Tomcat Inox; so, I can see where everything is supposed to go.)
Did you polish the sear surface?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top