Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
776 Posts
Discussion Starter · #1 ·
I'm primarily and brass reloader, but recently, I bought several shotshell reloaders in a "deal". One is a Pacific DL 155. It was set up to reload 2 1/2" shells. I tried 3 inchers, but it collapses the hull right above the high brass on the final stage.

Question: Is the final die - the one that finishes the crimp - supposed to go completely to the bottom of the finished hull. If not, is there something I'm doing wrong?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top