Gunboards Forums banner
1 - 4 of 4 Posts

· Registered
27 Posts
Discussion Starter · #1 ·
I'm considering making some of the adjustable rear sight elevation screws. Is there much need of them to consider making a batch of them? Need to know what threads they are? Anyone know? This is as close as I can figure. .115 OD x 72 TPI in English thread or 3mmX.37 in metric ????? Thanks, rj
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.