Gunboards Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
360 Posts
Discussion Starter · #1 ·
I am getting ready to mount my scope mount that I got Creedmoor tonight and looked and the mount does not set flat on the receiver. After I put into the rear sight dovetail the front on the mount is at a angle down. If push down on the rear part of the mount there is a gap under the front of the mount. Is this whey you shim the front of the mount to get enough elev for longer range targets. Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top